Loading

Click here

to join our Facebook group for

RTS sublimation blanks,

pre-sales and special offers

ATTENTION:

3 DAYS ONLY

FALL FLASH FRENZY!!

GET 25% OFF WITH FALL25

    Sublimation Glass Cutting Board / Trivet

    • Tempered Glass 
    • 8 x 11 inches 
    • Frosted surface
    • Single sided for sublimation 

    Tip:  STEP 1: Trim excess blank paper from non-mirrored, printed transfers

    to leave 2” of white space around your cutting-board-shaped, full-bleed graphic.

    This makes it easier for the transfer paper and image

    to conform to the slightly-beveled edges of the cutting board.

    Use at least 1/8” bleed on each side to better ensure your graphic hits all edges.

    STEP 2: Set towel/pad centered on the bottom platen of your open heat press.

    Then place 1 sheet of blowout paper on top of the towel/pad.

    STEP 3: Lay your trimmed transfer image side up

    (last chance to make sure you did not mirror print the transfer.)

    STEP 4: Place cutting board coated side down facing the transfer.

    STEP 5: Take your time aligning the cutting board to your graphic.

    Secure two of the transfer’s edges to the top of the cutting board using small pieces of heat tape.

    STEP 6: On the top, place over the cutting board 1 sheet of blow-out paper larger than the board.

    Customer Reviews

    Based on 1 review
    100%
    (1)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    P
    P.M.

    I love these glass cutting boards so hapoy it's back in stock

    Search