Sold Out
• 11 X 8 Inches
• Glass
Tip:
STEP 1: Trim excess blank paper from non-mirrored, printed transfers
to leave 2” of white space around your cutting-board-shaped, full-bleed graphic.
This makes it easier for the transfer paper and image
to conform to the slightly-beveled edges of the cutting board.
Use at least 1/8” bleed on each side to better ensure your graphic hits all edges.
STEP 2: Set towel/pad centered on the bottom platen of your open heat press.
Then place 1 sheet of blowout paper on top of the towel/pad.
STEP 3: Lay your trimmed transfer image side up
(last chance to make sure you did not mirror print the transfer.)
STEP 4: Place cutting board coated side down facing the transfer.
STEP 5: Take your time aligning the cutting board to your graphic.
Secure two of the transfer’s edges to the top of the cutting board using small pieces of heat tape.
STEP 6: On the top, place over the cutting board 1 sheet of blow-out paper larger than the board.